Inside: SereneScreen Fan Forum - View Single Post

Jim Sachs · 11-10-2008, 03:50 AM

OK, it's up: http://www.fish-byte.com/MA3Beta.zip

I just threw in the last part of the bezel-gap adjustment code without testing it, so good luck. The way it's SUPPOSED to work is: If you want to move Monitor 1 to the left, you would press the "1" key and the Left Arrow at the same time. Monitor 1 should slowly move, while Monitor 2 remains stationary. As of now, this setting IS NOT REMEMBERED.

I rewrote most of the Fishpicker code to (hopefully) eliminate the problems that James had reported. It would probably be best if you delete the Registry entries for CurrentFishSet, FishSetList, and NumFishSets in HKEY_CURRENT_USER/Software/SereneScreen/MarineAquarium3 . That way, the new interface code has a clean start.

Moderator's Note: You can download and run the MA3 Fish Picker Reset Registry script to reset your fish picker settings.

11-10-2008, 03:50 AM	#5
Jim Sachs Developer Join Date: Dec 2000 Location: Southern Oregon Posts: 9,774	OK, it's up: http://www.fish-byte.com/MA3Beta.zip I just threw in the last part of the bezel-gap adjustment code without testing it, so good luck. The way it's SUPPOSED to work is: If you want to move Monitor 1 to the left, you would press the "1" key and the Left Arrow at the same time. Monitor 1 should slowly move, while Monitor 2 remains stationary. As of now, this setting IS NOT REMEMBERED. I rewrote most of the Fishpicker code to (hopefully) eliminate the problems that James had reported. It would probably be best if you delete the Registry entries for CurrentFishSet, FishSetList, and NumFishSets in HKEY_CURRENT_USER/Software/SereneScreen/MarineAquarium3 . That way, the new interface code has a clean start. Moderator's Note: You can download and run the MA3 Fish Picker Reset Registry script to reset your fish picker settings. Jim Sachs Creator of SereneScreen Aquarium Last edited by feldon34; 11-10-2008 at 01:32 PM.