I just receive the SereneScreen Aquarium Version 1.1.2.319 widescreen version and then prompt to test it
the first thing I tested was to see if it can display in extended window(dual monitor)
I first install it without no problem
then I turn on the extended window mode under nView setting page as following (bote the split SSA on it is just an example)
after that my desktop resolution become 1600 x 600
of coz it's distored now, then I execute the SSA wide to see,
hopefully it'll extended the rest part of SSA to another monitor
but I doubt it,becoz the resolution isn't supported in SSA (1600 x 600)
so anyway, I tried...
the following snapshoot was the result
when SSA kicked in
this pops up
after clicking OK button this pops up
after clicking the OK button again this pops up
the above is the pop up which ask me to report the problem to MSFT
this is the pop up when I clicking the "detail" link on it
too bad it's surely cannot display in dual monitor.
maybe the method of my setting of dual monitor was totally wrong,if someone knows the correct, feel free to correct me
I'll test after functions of this wide beta version
if I found any problem........I'll report on this thread again
comments from anyone is welcome